Parts of the PC board are supplied with 120 volts AC.ĥ. Ensure that the manometer is properly calibrated.ĭo not touch any other areas on the PC board besides the “SW” switches while power is supplied to the appliance. Both ports must be used in order to measure the differential pressure. Remove two test point screws (1/8 NPT tap) with 3/16 Allen wrench and attach the manometer to both test ports. Pull the panel out at the bottom about 4 inches (100 mm) and lift up over clips that hold it in place at the unit’s top.Ĥ. Remove the 7 screws that hold the front panel and the louver assembly to remove panel from the unit. Hold both ends of the bottom cover (undercover assembly) and pull toward you to remove the cover. Rinnai Corporation RHFE-263FA Conversion Manualġ. No parts need to be replaced for high altitude.įor high altitude installations in Canada, the conversion shall be carried out by a manufacturer’s authorized representative, in accordance with the requirements of the manufacturer, provincial or territorial authorities having jurisdiction and in accordance with the requirements of CAN/CGA-B149.1 or CAN/CGA-B149 installation codes. #RINNAI ENERGYSAVER RHFE 263FA N BLINKING 12 CODE#The input rate can be verified by following the procedure in the National Fuel Gas Code (NFPA54 / ANSI Z223.1, 2006 or latest edition).Ĭonversion of the appliance for operation at high altitudes (> 2000 ft, 610 m) requires the completion of the section, Adjust Gas Pressure Settings, using the high altitude manifold test pressures above. High Altitude - Manifold test pressure (High) High Altitude - Manifold test pressure (Low) It may also be used to alert against unsafe practices. Indicates a potentially hazardous situation which, if not avoided, could result in minor or moderate injury. Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. This symbol alerts you to potential hazards that can kill or hurt you and others. An acceptable form of identification is required to vote in person at your polling place.This is the safety alert symbol. If you're voting on Election Day, polls will be open from 6 a.m. Ballot drop boxes will also be provided during voting hours at early voting sites and at all polling places from 6 a.m. 8 front of the Fairfax County Government Center 24/7 under video surveillance. A ballot drop box is available until 7 p.m. 14.īallots can be returned by mail or ballot drop boxes. Completed ballots must be returned to the Office of Elections by 7 p.m. Mail-in ballots may be requested by visiting, downloading an application on the Office of Elections website or picking up a paper application at any Fairfax County governmental center or library branch.Īpplications to request a mail-in ballot are due by Oct. Virginia voters do not need an excuse to request a mail-in ballot. 4īurke Centre Library, Centreville Regional Library, Franconia Governmental Center, Great Falls Library, Herndon-Fortnightly Library, Lorton Community Center, Mason Governmental Center, McLean Governmental Center, Providence Community Center, Sully Governmental Center, Thomas Jefferson Library, Tysons-Pimmit Regional Library, West Springfield Governmental Center
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |